Fused WDM 1310/1550nm
SENKO’s 1310/1550nm fused single-mode wavelength division multiplexers are manufactured using the proven fused biconical taper technology, this device is ideal for combining or separating optical signals in the 1310 and 1550nm bands.
- Low Loss
- High Isolation
- RoHS Compliant
- High Repeatability
|Operating Wavelength (nm)||1295~1325 / 1535~1565|
|Insertion loss Max. (dB)¹²||0.3|
|Isolation Min. (dB)||17|
|Return loss Min. (dB)¹||55|
|Directivity Min. (dB)||55|
|PDL Max. (dB)||0.1|
|WDL Max. (dB)||0.15|
|TDL at -5~70°C Max. (dB)||0.15|
|Housing dimension||250µm fiber 3.0mm (Ø) x 54mm (L)|
|900µm tube 4.0mm (Ø) x 54mm (L)|
|2mm/3mm tube, ABS Box: 90mm(L)x14mm(W)x8.5mm(H)|
|Fiber Type||SMF-28e 250µm bare fiber|
|Operating temperature (°C)||-40 to +85|
|Storage temperature (°C)||-40 to +85|
|Maximum Input Power (mW)||500|
1. The performance are not including the Connectors.
2. IL are worst case including PDL, TDL, and WDL.
Local Area Networks (LAN)
WDM is an acronym for Wavelength Division Multiplexer. The main purpose of the WDM is to increase bandwidth capabilities on a single optical fiber. Signals are sent using different wavelengths across one fiber channel until they are split into their respective lanes. The splitting is called demultiplexing. In reverse, the WDM can combine or multiplex the different wavelengths onto one fiber. This greatly increases the amount of information that can be sent over a single fiber.
CWDM is an acronym for Course Wavelength Division Multiplexer. CWDM is a type of WDM technology, however, the channel spacing is controlled to a recommended spacing called the ITU CWDM grid. In this grid, the channel spacing is 20nm with a channel passband of +/-6.5nm in the center wavelength. According to the ITU grid, the wavelength range is 1270nm to 1610nm where there are 18 individual channels separated by 20nm spacing.
DWDM is an acronym for Dense Wavelength Division Multiplexer. Similar to CWDM’s, a DWDM allows the multiplexing and demultiplexing of more than one wavelength that can be transmitted over one fiber. The difference here, is that the spacing is more dense. This means that the spacing is spaced at 0.8nm/0.4nm for DWDM’s. The wavelength used are from 1525nm to 1625nm which are known as the C Band and L Band wavelength ranges. DWDM’s allow for more channels due to the tight channel spacing.
A regular splitter has no wavelength dependency. This means that if 1310nm or 1550nm get sent into a splitter, both wavelengths are split into the ratio of the splitter. For a WDM, the device will actually block the light from with the wrong wavelength entering the channel and only pass the wavelength that it’s designed to allow through.